Dell N1100-ON

Security Commands 922
console(config)#radius-server attribute 4 192.168.10.22
radius-server attribute 6
Use the radius-server attribute 6 command to configure the use of the
RADIUS Service-Type attribute.
Syntax
radius-server attribute 6 [on-for-login-auth|mandatory]
no radius-server attribute 6 [on-for-login-auth|mandatory]
Default Configuration
By default, the switch does not send the Service-Type attribute to the
RADIUS server in the Access-Request packets. By default, the switch ignores
the Service-Type received in Access-Accept packets.
Command Mode
Global Configuration
User Guidelines
on-for-login—This parameter globally configures the switch to send the
RADIUS Service-Type attribute in the Access-Request message sent to all
RADIUS authentication servers. The switch sends the Service-Type value
Administrative (6) for administrators attempting to access the switch console
and sends Service-Type value Login (1) for users attempting to access the
network.
mandatory—This parameter enables processing and validation of the Service-
Type parameter received from the RADIUS server in Access-Accept messages.
Dell EMC Networking N-Series switches accept the Login-User (1) or
Administrative-User (6) values in the Access-Accept message returned from
the RADIUS server. Access-Accept messages without one of those values are
treated as if an Access-Reject message has been received.
Command History
Introduced in version 6.3.0.1 firmware. Updated in 6.3.0.5 firmware.