Dell N1100-ON

Layer 2 Switching Commands 306
Example
In this example, all classes of entries in the bridge-forwarding database for
Gigabit Ethernet interface 1/0/1 are displayed.
console#show mac address-table interface gigabitethernet 1/0/1
Aging time is 300 Sec
Vlan Mac Address Type Port
---- -------------- ---- -------------
1 0000.0001.0000 Dynamic Gi1/0/1
1 0000.8420.5010 Dynamic Gi1/0/1
1 0000.E26D.2C2A Dynamic Gi1/0/1
1 0000.E89A.596E Dynamic Gi1/0/1
1 0001.02F1.0B33 Dynamic Gi1/0/1
show mac address-table static
Use the show mac address-table static command in User Exec or Privileged
Exec mode to display static entries in the bridge-forwarding database.
Syntax
show mac address-table static [address mac-address] [interface interface-id]
[vlan vlan-id]
• mac-address — A MAC address with the format xxxx.xxxx.xxxx.
• interface-id — Specify an interface type; valid interfaces include Ethernet ports
and port channels.
• vlan-id — Specify a valid VLAN; the range is 1 to 4093.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec mode, Global Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.