Layer 3 Routing Commands 1323
Command History
Introduced in version 6.2.0.1 firmware.
Example
BGP table version is 0, local router ID is 65.1.1.1
Status Codes: s suppressed, * valid, > best, i - internal
Origin Codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPref Path
------------------ --------------- --------- ---------- ----------
show bgp ipv6 listen range
Use the show bgp ipv6 listen range command to display information about
IPv6 BGP listen ranges.
Syntax
show bgp ipv6 [vrf vrf-name] listen range [ network/length ]
•
network/length
— Displays information about the specified listen range.
• vrf-name—The name of a previously configured VRF.
Status codes
• s—The route is aggregated into an aggregate address
configured with the summary-only option
• *—Dell EMC Networking BGP never displays invalid
routes; so this code is always displayed (to maintain
consistency with the industry standard)
• >—Indicates that BGP has selected this path as the
best path to the destination
•
i—If the route is learned from an internal peer
Network IPv6 Destination prefix
Next Hop The route’s BGP next hop
Metric Multi-Exit Discriminator
LocPrf The local preference
Path The AS path
To Next Page
Loading...
