Layer 2 Switching Commands 715
show classofservice trust
Use the show classofservice trust command to display the current trust mode
setting for a specific interface.
Syntax
show classofservice trust [{gigabitethernet unit/slot/port|
port-channel port-
channel-number
| tengigabitethernet unit/slot/port | fortygigabitethernet
unit/slot/port}]
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
If the interface is specified, the port trust mode of the interface is displayed.
If omitted, the port trust mode for global configuration is shown.
Example
The following example displays the current trust mode settings for the
specified port.
console#show classofservice trust gigabitethernet 1/0/2
Class of Service Trust Mode: Dot1P
show diffserv
Use the show diffserv command to display the DiffServ general information,
which includes the current administrative mode setting as well as the current
and maximum number of DiffServ components.
NOTE: On the N1500 Series switches, enable Simple RED since the
hardware is not capable of Weighted RED.
To Next Page
Loading...
