Layer 3 Routing Commands 1608
Command Mode
Global Configuration mode
User Guidelines
The default interval for a Candidate Rendezvous Point (C-RP) to send C-RP
Advertisement messages to the Bootstrap Router (BSR) is 60 seconds.
Example
console(config)#ipv6 pim rp-candidate vlan 6 ff1e::/64
ipv6 pim sparse-mode
Use the ipv6 pim sparse-mode command to administratively configure PIM
sparse mode for multicast routing. This command also enables MLD. Use the
no form of this command to disable PIM and MLD.
Syntax
ipv6 pim sparse-mode
no ipv6 pim
Default Configuration
IPv6 PIM sparse mode is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
Only one of sparse or dense mode can be configured on a router. DVMRP
must be disabled before enabling PIM.
Example
console(config)#ipv6 pim sparse-mode
To Next Page
Loading...
