Data Center Technology Commands 1158
Gi1/0/3 0 0 0 0 0 0
show interfaces traffic-class-group
Use the show interfaces traffic-class-group command to display the Traffic
Class to Traffic Class Group mapping.
Syntax
show interfaces traffic-class-group [interface-id]
• interface-id—A valid physical interface specifier.
Default Configuration
The default is to show the global traffic class group configuration.
Command Mode
Privileged Exec mode
User Guidelines
NOTE: This command is only available on N40xx series switches.
The interface-id parameter is optional. If specified, the TCG mapping table
of the interface is displayed. If omitted, the global configuration settings are
displayed (these may have been subsequently overridden by per-port
configuration).
The following information is displayed:
Field Description
Interface Displays the slot/port of the interface. If displaying the global
configuration, this output line is replaced with a Global Config
indication.
Traffic Class Group The traffic class Group identifier.
Min-Bandwidth The minimum transmission bandwidth, expressed as a
percentage. A value of 0 means bandwidth is not guaranteed.
This is a configured value.
To Next Page
Loading...
