Dell N1100-ON

Layer 3 Routing Commands 1522
Syntax
ipv6 mld query-interval query-interval
no ipv6 mld query-interval
• query-interval — Query interval (Range: 1–3600).
Default Configuration
The default query interval is 125 seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld query-interval 130
ipv6 mld query-max-response-time
The ipv6 mld query-max-response-time command sets MLD query
maximum response time for the interface. This value is used in assigning the
maximum response time in the query messages that are sent on that
interface. Use the “no” form of this command to set the maximum query
response time to the default.
Syntax
ipv6 mld query-max-response-time query-max-response-time
no ipv6 mld query-max-response-time
• query-max-response-time — Maximum query response time (Range: 1–
65535 milliseconds).
Default Configuration
The default query maximum response time is 10 seconds.