Dell N1100-ON

Layer 3 Routing Commands 1674
Default Configuration
Global passive mode is disabled by default.
Command Mode
Router OSPF Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-router)#passive-interface
passive-interface
Use the passive-interface command to set the interface as passive. It
overrides the global passive mode that is currently effective on the interface.
Use the “no” form of this command to set the interface as non-passive.
Syntax
passive-interface vlan vlan-id
no passive-interface vlan vlan-id
• vlan-id — The VLAN number
Default Configuration
Passive interface mode is disabled by default.
Command Mode
Router OSPF Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-router)#passive-interface vlan 1