Dell N1100-ON

Layer 2 Switching Commands 421
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Example
The following example identifies test as the protected group.
console#show switchport protected 0
Name......................................... test
show system mtu
Use the show system mtu command to display the configured MTU. The
MTU is set using the global system jumbo mtu command. This command
deprecates the show interfaces mtu command.
Syntax
show system mtu
Default Configuration
The default mtu size is 1518 bytes (1522 bytes for VLAN tagged frames).
Command Modes
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no usage guidelines.
Example
console #show system mtu