Security Commands 920
Command Mode
RADIUS Server Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(Config-auth-radius)#primary
priority
Use the priority command in RADIUS Server Configuration mode to specify
the order in which the servers are to be used, with 0 being the highest priority.
Syntax
priority priority
• priority — Sets server priority level. (Range 0-65535)
Default Configuration
The default priority is 0.
Command Mode
RADIUS Server Configuration mode
User Guidelines
User must enter the mode corresponding to a specific RADIUS server before
executing this command.
Example
The following example specifies a priority of 10 for the designated server.
console(config)#radius-server host 192.143.120.123
console(config-auth-radius)#priority 10
To Next Page
Loading...
