Layer 3 Routing Commands 1765
• areaid — Identifies the OSPF area whose ranges are being displayed.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays information about the area ranges for area 1.
console#show ipv6 ospf range 1
Area ID IPv6 Prefix/Prefix Length Lsdb Type Advertisement
--------- ------------------------- --------------- -------------
show ipv6 ospf stub table
Use the show ipv6 ospf stub table command to display the OSPF stub table.
The information below will only be displayed if OSPF is initialized on the
switch.
Syntax
show ipv6 ospf stub table
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
This command has no user guidelines.
To Next Page
Loading...
