Dell N1100-ON

Layer 2 Switching Commands 661
assign-queue
Use the assign-queue command in Policy-Class-Map Configuration mode to
modify the queue ID to which the associated traffic stream is assigned.
Syntax
assign-queue queueid
• queueid — Specifies a valid queue ID. (Range: integer from 0–6.)
Default Configuration
This command has no default configuration.
Command Mode
Policy-Class-Map Configuration mode
User Guidelines
The queue id is the internal queue number (traffic class), not the CoS value.
Use the show classofservice command to display the assignment of CoS and
DSCP values to internal queue numbers.
classofservice trust match dstip6 police-simple show diffserv service
brief
conform-color match dstl4port police-single-rate show interfaces cos-
queue
cos-queue min-
bandwidth
match ethertype police-two-rate show interfaces
random-detect
cos-queue random-
detect
match ip6flowlbl policy-map show policy-map
cos-queue strict match ip dscp random-detect
queue-parms
show policy-map
interface
diffserv match ip
precedence
random-detect
exponential-
weighting-constant
show service-policy
drop match ip tos redirect traffic-shape
mark cos match protocol service-policy vlan priority