Dell N1100-ON

Switch Management Commands 1975
Default Configuration
Uses the default set with the command aaa authentication enable.
Command Mode
Line Configuration mode
User Guidelines
Use of the no form of the command does not disable authentication. Instead,
it sets the authentication list to the default list (same as enable
authentication default).
Example
The following example specifies the default authentication method when
accessing a higher privilege level console.
console(config)# line console
console(config-line)# enable authentication default
exec-banner
Use the exec-banner command to enable exec banner on the console, telnet
or SSH connection. To disable, use the no form of the command.
Syntax
exec-banner
no exec-banner
• MESSAGE — Quoted text
Default Configuration
This command has no default configuration.
Command Mode
Line Configuration