Switch Management Commands 1917
service dhcp
Use the service dhcp command in Global Configuration mode to enable the
local IPv4 DHCP server on the switch. Use the no form of the command to
disable the DHCPv4 service.
Syntax
service dhcp
no service dhcp
Default Configuration
The service is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
sntp
Use the sntp command in DHCP Pool Configuration mode to set the IPv4
address of the NTP server to be used for time synchronization of the client.
Use the no form of the command to remove the NTP server configuration.
Syntax
sntp ip-address
no sntp
• ip-address—The IPv4 address of the NTP server to use for time services.
Default Configuration
There is no default IPv4 NTP server configured.
Command Mode
DHCP Pool Configuration mode
To Next Page
Loading...
