Layer 2 Switching Commands 428
Command Mode
Interface Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example creates a maintenance endpoint at level 1 with mpid
1010 on vlan 10.
console(config-if-Gi1/0/3)#ethernet cfm mep level 1 direction up mpid 1010
vlan 10
ethernet cfm mep enable
Use the ethernet cfm mep enable command in Interface Configuration mode
to enable a MEP at the specified level and direction. Use the no form of the
command to disable the MEP.
Syntax
ethernet cfm mep enable level 0-7 vlan vlan-id mpid 1-8191
• level—Maintenance association level
• mpid—
Maintenance entity identifier
• vlan—
VLAN on which the MEP operates. The range is 1-4093.
Default Configuration
No MEPs are preconfigured.
Command Mode
Interface Configuration mode
User Guidelines
The maintenance domain must exist for it to be enabled.
To Next Page
Loading...
