Layer 2 Switching Commands 832
traffic. See the User Configuration Guide for more information. Voice VLAN
is recommended for enterprise-wide deployment of voice services on the IP
network.
Commands in this Section
This section explains the following commands:
voice vlan
This command is used to enable the voice VLAN capability on the switch.
Syntax
voice vlan
no voice vlan
Command Mode
Global Configuration
User Guidelines
Voice VLAN must be configured on access or general mode ports. It is not
supported on trunk mode ports.
Default Value
This feature is disabled by default.
Example
console(config)#voice vlan
console(config)#no voice vlan
voice vlan (Interface)
This command is used to enable the voice VLAN capability on the interface.
voice vlan voice vlan data priority
voice vlan (Interface) show voice vlan
To Next Page
Loading...
