Dell N1100-ON

Switch Management Commands 2174
User Guidelines
This command has no user guidelines.
Example
console(config-if-Gi1/0/1)#load-interval 150
locate
Use the locate command to locate a switch by LED blinking.
Syntax
locate [switch unit ] [time time ]
• switch unit—If multiple devices are stacked, you can choose which
switch to identify.
• time time —LED blinking duration in seconds. Range 1-3600 seconds.
Default Configuration
Default value is 20 seconds.
Command Mode
Privileged Exec
User Guidelines
When this command is executed on N1100-ON/N1500/N2000/N2100-
ON/N3000/N3100-ON switches, the front panel power supply 1 LED blinks.
On N4000 switches, the back panel green Locator LED blinks.
The LED blinks until it times out. The user may select a new time value
while the LED is blinking. The last value selected takes effect immediately.
The locate command does not persist across reboots.
Example
console# locate switch 1 time 555