Dell N1100-ON

Layer 2 Switching Commands 368
show ipv6 source binding
Use the show ipv6 source binding command to display the IPv6 Source
Guard configurations on all ports, on an individual port, or on a VLAN.
Syntax
show ipv6 source binding [{dhcp-snooping | static}] [interface interface-id]
[vlan vlan-id]
• dhcp-snooping — Displays the DHCP snooping bindings.
• static —Displays the statically configured bindings.
Default Configuration
This command has no default configuration.
Command Modes
User Exec, Privileged Exec (all show modes)
User Guidelines
This command has no user guidelines.
Example
(console)#show ipv6 source binding
MAC Address IP Address Type Vlan Interface
----------------- --------------- ------------- ----- ---------
00:00:00:00:00:08 2000::1 dhcpv6-snooping 2 Gi1/0/1
00:00:00:00:00:09 3000::1 dhcpv6-snooping 3 Gi1/0/1
00:00:00:00:00:0A 4000::1 dhcpv6-snooping 4 Gi1/0/1
show ipv6 verify
Use the show ipv6 verify command to display the IPv6 Source Guard
configuration on all interfaces or the specified interface.
Syntax
show ipv6 verify [interface if-id]
• if-id—A valid interface ID (physical)