Dell N1100-ON

Dell EMC Networking CLI 120
LLDP
Command Description Mode
a
clear lldp remote-data Deletes all data from the remote data table. PE
clear lldp statistics Resets all LLDP statistics. PE
dcb enable Enables the sending of DCBX information in
LLDP frames.
GC
lldp med Enables/disables LLDP-MED on an interface. IC
lldp med confignotification Enables sending the topology change
notification.
IC
lldp med
faststartrepeatcount
Sets the value of the fast start repeat count. GC
lldp med transmit-tlv Specifies which optional TLVs in the LLDP
MED set are transmitted in the LLDPDUs.
IC
lldp notification Enables remote data change notifications. IC
lldp notification-interval Limits how frequently remote data change
notifications are sent.
GC
lldp receive Enables the LLDP receive capability. IC
lldp timers Sets the timing parameters for local data
transmission on ports enabled for LLDP.
GC
lldp transmit Enables the LLDP advertise capability. IC
lldp transmit-mgmt Specifies that transmission of the local system
management address information in the
LLDPDUs is included.
IC
lldp transmit-tlv Specifies which optional TLVs in the 802.1AB
basic management set will be transmitted in the
LLDPDUs.
IC
show lldp Displays the current LLDP configuration
summary.
PE
show lldp interface Displays the current LLDP interface state. PE
show lldp local-device Displays the LLDP local data. PE
show lldp med Displays a summary of the current LLDP MED
configuration.
PE