Dell N1100-ON

Dell EMC Networking CLI 122
feature vpc Globally enables MLAG. GC
peer detection enable
Enables the Dual Control Plane
Detection Protocol.
MD
peer detection interval
Configures the peer detection
transmission interval and the detection
interval.
MD
peer-keepalive destination Enables the Dual Control Plane Detection
Protocol with the configured IP address of
the peer MLAG, the local source address and
the peer timeout value.
MD
peer-keepalive enable Enables the peer keepalive protocol. MD
peer-keepalive timeout Configures the peer keepalive timeout value,
in seconds.
MD
role priority Configures the priority value used on a
switch for primary/secondary role selection.
MD
show vpc Displays information about an MLAG. PE
show vpc brief Displays the MLAG global status. PE
show vpc consistency-
parameters
Displays MLAG-related configuration
information in a format suitable for
comparison with the other MLAG peer.
PE
show vpc consistency-
features
Displays MLAG-related configuration
information in a format suitable for
comparison with the other MLAG peer.
PE
show vpc peer-keepalive Displays the peer MLAG switch’s IP address
used by the dual control plane detection
protocol.
PE
show vpc role Displays information about the keepalive
status, keepalive parameters, role of the
MLAG switch, and the system MAC and
priority.
PE
show vpc statistics Displays counters for the keepalive messages
transmitted and received by the MLAG
switch
PE
Command Description Mode
a