Dell N1100-ON

Dell EMC Networking CLI 111
Ethernet CFM
show system mtu Displays the configured MTU. PE
system jumbo mtu Globally configures the Maximum Transmission
Unit (MTU) on all interfaces for forwarded and
system-generated frames.
GC
a. For the meaning of each Mode abbreviation, see Mode Types .
Command Description Mode
a
ethernet cfm domain Enters into maintenance domain Configuration
mode for an existing domain. Use the optional
level parameter to create a domain and enter
into maintenance domain Configuration mode.
GC
service Associates a VLAN with a maintenance domain. MDC
ethernet cfm cc level Initiates sending continuity checks (CCMs) at
the specified interval and level on a VLAN
monitored by an existing domain.
GC
ethernet cfm mep level Creates a Maintenance End Point (MEP) on an
interface at the specified level and direction.
IC
ethernet cfm mep enable Enables a MEP at the specified level and
direction.
IC
ethernet cfm mep active Activates a MEP at the specified level and
direction.
IC
ethernet cfm mep archive-
hold-time
Maintains internal information on a missing
MEP.
IC
ethernet cfm mip level Creates a Maintenance Intermediate Point
(MIP) at the specified level.
IC
ping ethernet cfm Generates a loopback message (LBM) from
the configured MEP.
PE
traceroute ethernet cfm Generates a link trace message (LTM) from the
configured MEP.
PE
show ethernet cfm errors Displays the cfm errors. PE
show ethernet cfm domain Displays the configured parameters in a
maintenance domain.
PE
Command Description Mode
a