Layer 3 Routing Commands 1331
Command History
Introduced in version 6.2.0.1 firmware.
Modified in version 6.3.0.1 firmware.
Example
console#show bgp ipv6 neighbors fe80::211:12ff:fe06:4 interface vl10
advertised-routes
BGP table version is 10, local router ID is 0.0.0.100
Status codes: p - advertisement pending
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPref Path Origin
------------------ ---------------- ---------- ------- ------------- ------
1010:10::/64 0 i
2020:20::/64 0 i
Status Codes p – The route has been updated in Adj-RIB-Out since
the last UPDATE message was sent. Transmission of an
UPDATE message is pending.
Network The Destination prefix.
Next Hop The BGP Next Hop as advertised to the peer.
Metric The value of the Multi Exit Discriminator (MED), if
the MED is advertised to the peer.
LocPref The local preference. Local preference is never
advertised to external peers.
Path The AS path. The AS path does not include the local AS
number, which is added to the beginning of the AS path
when a route is advertised to an external peer.
Origin The value of the origin attribute.
• i—IGP
• e—EGP
• ?—Incomplete
To Next Page
Loading...
Need help?
General
