Dell N1100-ON

Dell EMC Networking CLI 139
RADIUS
Command Description Mode
a
acct-port Sets the port that connects to the RADIUS
accounting server.
R
attribute 6 Configures the switch to send the RADIUS
Service-Type attribute in the Access-Request
message sent to a specific RADIUS
authentication server.
R
attribute 8 Configures the switch to send the RADIUS
Framed-IP-Address attribute in the Access-
Request message sent to a specific RADIUS
authentication server.
R
attribute 25 Enables the switch to send the RADIUS Class
attribute as supplied by the RADIUS server in
accounting messages sent to the specific
accounting server.
R
attribute 31 Alters the format of the MAC address sent in
the Calling-Station-Id attribute to the RADIUS
server when authenticating using 802.1X MAC
based authentication for an interface.
R
authentication event fail
retry
Sets the number of times authentication may
be reattempted by the user for the RADIUS
method for an IEEE 802.1X supplicant.
GC
auth-port Sets the port number for authentication requests
of the designated radius server
.
R
deadtime Improves Radius response times when a server is
unavailable by causing the unavailable server to
be skipped.
R
key Sets the authentication and encryption key for all
RADIUS communications between the switch
and the RADIUS daemon
.
R
msgauth Enables the message authenticator attribute to
be used for the RADIUS Authenticating server
being configured.
R
name (RADIUS server) Assigns a name to a RADIUS server. R