Dell N1100-ON

Dell EMC Networking CLI 142
802.1x
tacacs-server source-
interface
Selects the interface from which to use the IP
address in the source IP address field of
transmitted TACACS packets.
GC
tacacs-server timeout Sets the interval for which the switch waits for a
server host to reply.
GC
timeout Specifies the timeout value in seconds. TC
a. For the meaning of each Mode abbreviation, see Mode Types .
Command Description Mode
a
dot1x dynamic-vlan enable Enables the capability of creating VLANs
dynamically when a RADIUS-assigned VLAN
does not exist in the switch.
GC
dot1x eapolflood Enables the flooding of received IEEE 802.1x
frames in the VLAN.
GC
dot1x initialize Begins the initialization sequence on the
specified port.
PE
dot1x mac-auth-bypass Enables MAB on an interface. IC
dot1x max-req Sets the maximum number of times the switch
sends an EAP-request frame to the client before
restarting the authentication process.
IC
dot1x max-users Sets the maximum number of clients supported
on the port when MAC-based 802.1X
authentication is enabled on the port.
IC
dot1x port-control Enables manual control of the authorization
state of the port.
IC
dot1x re-authenticate Manually initiates a reauthentication of all
802.1x-enabled ports or a specified 802.1X
enabled port.
PE
dot1x reauthentication Enables periodic reauthentication of the client. IC
dot1x system-auth-control
monitor
Enables 802.1X globally. GC
Command Description Mode
a