Dell N1100-ON

Layer 3 Routing Commands 1493
The VRF parameter is only available on the N3000/N3100/N4000 series
switches.
The Method field contains one of the following values.
Example
console#show ip interface
Default Gateway................................ 0.0.0.0
L3 MAC Address................................. 001E.C9DE.B546
Routing Interfaces:
Interface State IP Address IP Mask Method
---------- ----- --------------- --------------- -------
Vl1 Down 0.0.0.0 0.0.0.0 None
Vl2 Up unnumbered
-->loopback 2 N/A
console#
console#show ip interface vlan 1
Routing interface status....................... Up
Unnumbered - numbered interface................ Loopback 1
Unnumbered - gratuitous ARP accept............. Enable
Method......................................... None
Routing Mode................................... Enable
Administrative Mode............................ Enable
Forward Net Directed Broadcasts................ Disable
Proxy ARP...................................... Enable
Local Proxy ARP................................ Disable
Active State................................... Inactive
MAC Address.................................... 001E.C9DE.B546
Encapsulation Type............................. Ethernet
IP MTU......................................... 1500
Bandwidth...................................... 10000 Kbps
Destination Unreachables....................... Enabled
ICMP Redirects................................. Enabled
Field Description
DHCP The address is leased from a DHCP server.
Manual The address is manually configured.