Layer 3 Routing Commands 1591
• candidate – Shows the candidate routers capable of acting as the bootstrap
router.
• elected – Shows the router elected as the PIM bootstrap router.
Default Configuration
There is no default configuration for this command.
Command Mode
User Exec, Privileged Exec mode, Global Configuration mode and all
Configuration submodes
User Guidelines
The following information is displayed:
Example
console#show ip pim bsr-router
BSR Address............................. 192.168.10.1
BSR Priority............................ 0
BSR Hash Mask Length.................... 30
C-BSR Advertisement Interval (secs)........60
Next Bootstrap message(hh:mm:ss).......... NA
If no configured/elected BSRs exist on the router, the following message is
displayed.
No BSR’s exist/learned on this router.
Field Description
BSR address IP address of the BSR.
BSR Priority The configured BSR priority.
BSR Hash Mask Length The configured hash mask length (32 bits maximum).
Next Bootstrap Message
in
Time remaining (in hours, minutes, and seconds) until a
BSR message is sent.
Next Candidate RP
Advertisement
Time remaining (in hours, minutes, and seconds) until the
next RP advertisement is sent.
To Next Page
Loading...
