Dell N1100-ON

Layer 3 Routing Commands 1646
Syntax
bandwidth bw
• bw — Interface bandwidth in Kbps (Range: 1–10000000).
Default Configuration
The default reference bandwidth is 10 Mbps
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the interface bandwidth to 500000 Kbps.
console(config-if-vlan1)#bandwidth 500000
bfd
Use the bfd command to enable processing of BFD events by OSPF on all
interfaces enabled for BFD. Use the no form of the command to ignore BFD
events.
Syntax
bfd
no bfd
Default Configuration
The processing of BFD events is not enabled by default.
Command Mode
Router OSPF Configuration mode, Router OSPFv3 Configuration mode