Layer 3 Routing Commands 1699
• interface-type—Interface type – only supported type is vlan.
• interface-number—A valid interface number.
• neighbor-id—Valid IP address of the neighbor.
Default Configuration
This command has no default configuration.
Command Mode
User Exec, Privileged Exec modes, Global Configuration mode and all
Configuration submodes
User Guidelines
The VRF identified in the parameter must have been previously created or an
error is returned.
The VRF parameter is only available on the N3000/N3100/N4000 series
switches.
The following information is output.
Field Description
Interface The name of the interface on which the adjacency is formed.
Neighbor IP Address
The IPv4 address on the neighbor's interface used to form the
adjacency.
Interface Index The SNMP interface index.
Area Id The OSPF area in which the adjacency is formed.
Options
The options advertised by the neighbor.
Router Priority The router priority advertised by the neighbor.
Dead timer The number of seconds until the dead timer expires.
Up Time How long this adjacency has been in FULL state.
State The local state of the adjacency. The neighbor state is not
tracked locally.
To Next Page
Loading...
