Dell N1100-ON

Switch Management Commands 1996
console(config)#power inline management static
console(config)#interface gi1/0/1
console(config-if-Gi1/0/1)#power inline four-pair forced
console(config-if-Gi1/0/1)#power inline limit none
This example configures interface Gi1/0/2 to deliver 50W four-pair power
(within the 5% tolerance). The port will deliver up to 52500 mW.
console#configure
console(config)#power inline management static
console(config)#interface gi1/0/2
console(config-if-Gi1/0/2)#power inline four-pair forced
console(config-if-Gi1/0/2)#power inline limit user-defined 50000
This example displays an interface configured in four-pair power mode.
console#show power inline gigabitethernet 1/0/1 detailed
Port Powered Device State Priority Status Class Power[mW]
--------- ------------------------ ----- -------- ---------- ------- -------
--
Gi1/0/1 auto Low Searching Unknown
Limit Power High Power
Port Type Limit Mode
--------- -------- -------- -----------
Gi1/0/1 None 57000 Enabled
Overload Counter............................... 0
Short Counter ................................. 0
Denied Counter................................. 0
Absent Counter................................. 0
Invalid Signature Counter...................... 0
Output Volts................................... 53
Output Current................................. 0
Temperature.................................... 49
Command History
Description revised in 6.3.5 release.