Switch Management Commands 2103
• all—Enable all traps (not recommended).
• auto-copy-sw—Enable traps on automatic download of switch software.
• bgp state-changes limited—Enable the two traps defined in the
standard BGP MIB, RFC 4273. A trap is sent when an adjacency reaches
the ESTABLISHED state and when a backward adjacency state
transition occurs.
• captive-portal—Enable captive-portal traps.
• dot1q—Enable traps on VLAN configuration failures.
• bgp state-changes limited—Enable standard traps defined in RFC 4273.
• port-security—Enable traps on port security violations.
• port-security trap-rate—Configure the interval at which port security
traps are issued. Range 1-1000000 seconds. Default 30 seconds.
• buffers—Enables sending of a trap on the internal message buffer count
exceeding the rising threshold.
• cpu threshold—Enables sending of a trap on the CPU occupancy
exceeding the rising threshold.
• multiple-users—Enable sending a trap when multiple logins are active.
• link—Enable sending a trap when a link (interface) transitions to the
active state or the inactive state.
• violation—Enable sending a trap when a port security MAC locking
violation occurs.
• vrf-name—The name of an existing VRF instance
• dvmrp—Enable dvmrp traps.
• port-security —Enable traps on port security violations.
• ospf—Enable OSPF event traps.
• ospfv3—Enable OSPFv3 event traps.
• pim—Enable pim traps (pim-sm and pim-dm).
• poe —Enable poe traps. This parameter is only available on PoE capable
switches.
• snmp authentication —Enable snmp authentication traps.
• spanning-tree—Enable traps on topology changes.
• vrrp —Enable vrrp traps.
To Next Page
Loading...
