Dell N1100-ON

Dell EMC Networking CLI 211
connect Connects to the serial console of a different
stack member.
PE
cut-through mode Enables cut-through mode on the switch (if
supported).
GC
exit Disconnects the serial connection to the remote
unit.
UE
hardware profile
portmode
Configures a 40G port in 4x10G mode or
1x40G mode.
IC
hostname Specifies or modifies the switch host name. GC
initiate failover Forces failover of management unit. GC
load-interval Loads the interface utilization measurement
interval.
IC
locate Locates a switch by LED blinking. PE
logout Disconnects the serial connection to a remote
unit on a stack member.
UE
member Preconfigures a stack member. SG
memory free low-
watermark
Configures the notification of a low memory
condition on the switch for the issuance of the
CPU overload SNMP trap and notification via a
SYSLOG message.
GC
nsf Specifies non-stop forwarding. GC
ping Sends ICMP echo request packets to another
node on the network.
UE
process cpu threshold Configures the rising and falling thresholds for
the issuance of the CPU overload SNMP trap
and notification via a SYSLOG message.
GC
quit Disconnects the serial connection to the remote
unit on a stack member.
UE
reload Reloads the operating system. PE
set description Associates a text description with a switch in
the stack.
SG
slot Configures a slot in the system. GC
Command Description Mode
a