Dell N1100-ON

Switch Management Commands 2156
Default Configuration
The default setting is that system messages are not displayed on telnet or
SSH sessions. System messages are always displayed on console sessions
(serial or out-of-band port connections).
Command Mode
Privileged Exec mode
User Guidelines
Use the terminal monitor command enables system messages to be displayed
in a Telnet or SSH session.
Use the no terminal monitor command to disable the display of system
messages on the terminal for Telnet and SSH sessions. Use the logging
monitor command to display logging messages in a Telnet or SSH session.
Terminal monitor and logging monitor are enabled on console sessions by
default.
Example
This example enables the display of system messages and logging messages on
the current telnet session.
console#terminal monitor
console#configure
console(cinsfig)#logging monitor