Dell N1100-ON

Switch Management Commands 2214
If you supply a value for cardindex, the following additional information
appears as shown in the table below.
Example
This example shows the supported card types for the Dell EMC Networking
N4000 switch.
console>show supported cardtype
CID Card Model ID
--- --------------------------------
1 XLP308 Base CPU Card
2 Dell Networking N4032
3 Dell Networking N4032F
4 Dell Networking N4064
5 Dell Networking N4064F
6 Dell QSFP Card
7 Dell SFP+ Card
8 Dell 10GBase-T Card
Command History
Description updated in the 6.4 release.
Parameter Description
Card Index (CID) The index into the database of the
supported card types. This index is used
when preconfiguring a slot.
Card Model Identifier The model identifier for the supported
card type.
Parameter Description
Card Type The 32-bit numeric card type for the
supported card.
Model Identifier The model identifier for the supported
card type.
Card Description The description for the supported card
type.