Dell N1100-ON

Switch Management Commands 2243
• initTtl—The initial time-to-live (TTL); the maximum number of router
hops between the local and remote system (Range: 1–255). the default is
1.
• maxTtl—The largest TTL value that can be used (Range:1–255). The
default is 30. This must be larger or equal to the value specified in
initTtl.
• maxFail—Terminate the traceroute after failing to receive a response for
this number of consecutive probes (Range: 1–255).
• interval—The timeout period. If a response is not received within this
period of time, then traceroute considers that probe a failure (printing
*) and sends the next probe. If traceroute does receive a response to a
probe, then it sends the next probe immediately. (Range: 1–60 seconds).
The default is 3.
• count—The number of probes to be sent at each TTL level (Range:1–
10).
• port—The destination UDP port of the probe. This should be an
unused port on the remote destination system (Range: 1–65535).
• size—The size, in bytes, of the payload of the Echo Requests sent
(Range: 0–39936 bytes). The default is 0.
• src-ip-address—The IPv4 source address to use in the ICMP echo
request packets.
• vlan-id—The source VLAN over which to send the echo request.
• loopback-id—A configured loopback ID
Default Configuration
The default count is 3 probes.
The default interval is 3 seconds.
The default size is 0 data bytes.
The default port is 33434.
The default initTtl is 1 hop.
The default maxTtl is 30 hops.
The default maxFail is 5 probes.