Dell N1100-ON

Switch Management Commands 2266
Command Mode
User Exec and Privileged Exec modes
User Guidelines
If there is no authentication method defined for enable, then a privilege level
1 user is not allowed to execute this command.
Example
The following example shows how to enter privileged mode.
console>enable
console#
end
Use the end command to return the CLI command mode back to the
privileged execution mode or user execution mode.
Syntax
end
Default Configuration
This command has no default configuration.
Command Mode
All command modes
User Guidelines
The first invocation of end from Global Configuration mode, or any
configuration submode, returns the command mode to Privileged Exec mode.
This command is equivalent to using the Ctrl-Z key press.
Example
console(config)#end
console#end
console>