239
Effect WIPE 100 patterns, Border and Softness
DVE 56 patterns or more (2D, 3D and 2-channel)
Transition Execution: Fader lever, AUTO or CUT button
Type: MIX or WIPE (DVE included)
Still/Clip Memory 4 still buffers with backup feature
4 clip buffers (Recording capacity: 2 seconds for each, expandable up
to 4 seconds with HVS-39MEM)
Key 8 channels (4 keys on each M/E)
Luminance, Full or Bus key,
2D DVE on each channel
KEY1, KEY2: Chroma key, Edge/shadow effects
KEY3, KEY4: Direct display on AUX outputs possible
Multiviewer 2 channels with 4-, 10- or 16-way split views
Display: Title, Tally, Audio Level Meter, Safety Area and Frame Border
1 frame delay relative to PGM output
Process Amp Process Amp feature on each input
Color Correction 4 channels (2 channels for each M/E)
Correction mode: Balance, Differential and Sepia
Clip mode: YPbPr, RGB
Event Memory 100 events
Sequence Memory 10 sequences (up to 60 steps for each)
Genlock Input BB: NTSC: 0.429 Vp-p/PAL: 0.45Vp-p or Tri-level Sync: 0.6 Vp-p
75Ω BNC x 1, loop-through (Terminate with 75Ω terminator, if unused.)
System Phase Adjust Horizontal: -1/2H to +1/2H
Genlock Output BB: NTSC: 0.429 Vp-p/PAL: 0.45Vp-p or Tri-level Sync: 0.6 Vp-p
75Ω BNC x 1
I/O Delay Minimum delay: HD: 1H, SD: 1.7H
If FS or Up-resize engine used: 1 to 2 frames + Minimum delay
If FS or Up-resuze engine plus DVE
used:
2 to 3 frames + Minimum delay
FS or Up-resize engine plus Output
resize engine and DVE used:
3 to 4 frames + Minimum delay
Interfaces
Ethernet 100Base-TX/100BASE-T RJ-45 x 1
GPI IN 15-pin D-sub (female) x 1 (inch screw) 10 inputs,
TTL negative logic pulse or Make-contact
GPI/TALLY OUT 25-pin D-sub (female) x 1(inch screw) 20 outputs
GPI IN/TALLY OUT
(HVS-391OU)
15-pin D-sub (female) x 1 (inch screw) 6-input/6-outputs, TTL negative
logic pulse or Make-contact
TALLY OUT
(with HVS-30TALR)
37-pin D-sub (female) x 1 (with inch screws), Make-contact (18 outputs
added per card, up to 2 cards available)
RS-422 9-pin D-sub (female) x 6 (with inch screws)
* For HVS-30RU, VTR, router and tally unit connection
EDITOR 9-pin D-sub (female) x 1 (with inch screws)
BVS-3000 or GVG protocol
ARCNET
75Ω BNC x 1, loop-
through (Terminate with 75Ω terminator, if unused.)
* For control panel and AUX remote panel connection
To Next Page
