Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

After replacing or upgrading LAN controllers
▶
You need to restore the configuration for the LAN T
eaming, using the LAN
driver utility or OS teaming software.
Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
For more information, see the relevant LAN driver manual.
After replacing a system board
The following procedure must be done for each system board that is
replaced.
▶
Confirm with the customer whether the onboard LAN controller you have
replaced has been used as part of a LAN teaming configuration.
▶
If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility or OS teaming software.
For more information, see the relevant LAN driver manual.
5.3.16 Switching off the ID indicator
▶
Press the ID button on the front panel, or use the ServerView Operations
Manager
, the iRMC S5 web interface or the Infrastructure Manager to switch
off the ID indicator after the maintenance task has been concluded
successfully.
For more information, see "Locating the defective server" on page 49
or
the "ServerView Suite Local Service Concept (LSC)", the iRMC user
guides or the Infrastructure Manager documentation.
Using the ID button on the front panel
▶
Press the ID button on the front panel to switch off the ID indicators.
Basic software procedures
114 Upgrade and Maintenance Manual RX2540 M6

Fujitsu PRIMERGY RX2540 M6 Specifications

General

Memory Slots	32 DIMM slots
Form Factor	2U rack server
Processor	Intel Xeon Scalable Processors (3rd generation)
Storage	Up to 24 x 2.5" or 12 x 3.5" drives
RAID Support	RAID 0, 1, 5, 6, 10
Network	4 x 1GbE ports (onboard), optional 10/25GbE
Power Supply	800 W, 1200 W, 1600 W
Expansion Slots	Up to 8x PCIe Gen4 slots
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware
Management	iRMC S5