Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

For more information on iRMC settings, see the iRMC user guides.
5.3.6 Enabling the boot watchdog
If the boot watchdog has been disabled for firmware upgrade purposes (see
"Disabling the boot watchdog" on page 88
), it has to be re-enabled to complete
the maintenance task.
Timer settings can be configured in the BIOS or using the iRMC S5 web
interface.
Enabling the boot watchdog in the BIOS
▶
Enter the BIOS.
▶
Select the Management menu.
▶
Under Boot Watchdog set the Action setting to Reset.
▶
Save your changes and exit the BIOS.
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
Enabling the boot watchdog using the iRMC S5 web interface
▶
Log in to the iRMC S5 web interface.
▶
Select the Settings menu.
▶
Open the Server Management page.
▶
In the Boot W
atchdog group, check the
Enable Boot Watchdog option.
The Enable Boot Watchdog option must be selected.
▶
Select Reset from the Watchdog Action list.
▶
Click Apply for the changes to take effect.
For more information on iRMC settings, see the iRMC user guides.
Basic software procedures
RX2540 M6 Upgrade and Maintenance Manual 99

Fujitsu PRIMERGY RX2540 M6 Specifications

General

Memory Slots	32 DIMM slots
Form Factor	2U rack server
Processor	Intel Xeon Scalable Processors (3rd generation)
Storage	Up to 24 x 2.5" or 12 x 3.5" drives
RAID Support	RAID 0, 1, 5, 6, 10
Network	4 x 1GbE ports (onboard), optional 10/25GbE
Power Supply	800 W, 1200 W, 1600 W
Expansion Slots	Up to 8x PCIe Gen4 slots
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware
Management	iRMC S5