16.8.3 Replacing the VROC module
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: tool-less
Preliminary steps
▶
If applicable, "Removing the front cover with lock" on page 52
.
▶
"Shutting down the server" on page 52.
▶
"Disconnecting the power cord" on page 53.
▶
"Getting access to the component" on page 56.
Replacing the VROC module
▶
Disconnect the VROC module from the VROC connector on the system
board, see "Removing the VROC module" on page 517.
▶
Connect the VROC module to the VROC connector on the system board,
see "Installing the VROC module" on page 516.
Concluding steps
▶
"Reassembling" on page 60.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 69.
▶
If applicable, "Installing the front cover with lock" on page 69.
System board and components
RX2540 M6 Upgrade and Maintenance Manual 519
To Next Page
Loading...
