Ensure that the PSU engages correctly in the bay and is locked in
position.
Figure 44: Installing the cable clamp
▶
Only for AC PSU: push the cable clamp into the corresponding hole until it
clicks in.
Concluding steps
▶
"Connecting the power cord" on page
65
.
6.3.2 Removing a hot-plug PSU
Customer Replaceable
Unit (CRU)
Hardware: 5 minutes
Tools: Phillips PH1 / (+) No. 1 screw driver (for DC PSU -48 V)
The procedure of removing an AC PSU or a DC PSU differs only in
disconnecting/connecting the power cord.
Power supply unit (PSU)
RX2540 M6 Upgrade and Maintenance Manual 127
To Next Page
Loading...
