Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

Tools: hexagon screw driver 5 mm
Preliminary steps
▶
If applicable, "Removing the front cover with lock" on page 52
.
▶
"Shutting down the server" on page 52.
▶
"Disconnecting the power cord" on page 53.
▶
"Getting access to the component" on page 56.
Removing the defective serial interface
▶
Remove the serial interface, see "Removing the serial interface" on
page 467.
Installing the new serial interface
▶
Install the serial interface, see "Installing the serial interface" on page 463.
Concluding steps
▶
"Reassembling" on page 60.
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 69.
▶
If applicable, "Installing the front cover with lock" on page 69.
15.3 Rear VGA connector
15.3.1 Replacing the rear VGA
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Additional interfaces
470 Upgrade and Maintenance Manual RX2540 M6

Fujitsu PRIMERGY RX2540 M6 Specifications

General

Memory Slots	32 DIMM slots
Form Factor	2U rack server
Processor	Intel Xeon Scalable Processors (3rd generation)
Storage	Up to 24 x 2.5" or 12 x 3.5" drives
RAID Support	RAID 0, 1, 5, 6, 10
Network	4 x 1GbE ports (onboard), optional 10/25GbE
Power Supply	800 W, 1200 W, 1600 W
Expansion Slots	Up to 8x PCIe Gen4 slots
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware
Management	iRMC S5