Preliminary steps
▶
"Suspending BitLocker functionality" on page 87
.
▶
If applicable, "Removing the front cover with lock" on page 52.
▶
"Shutting down the server" on page 52.
▶
"Disconnecting the power cord" on page 53.
▶
"Getting access to the component" on page 56.
▶
Remove all riser modules, see "Removing a riser module" on page 70.
▶
"Removing the cross bar" on page 80.
▶
If necessary, remove the cables from the expansion cards.
▶
"Removing the air duct" on page 78.
Removing the defective GPU card
▶
Remove the GPU card, see "Removing the GPU card from a riser module
(example NVDIA Tesla A100)" on page 307 or "Removing the GPU card
from a riser module (example NVDIA RTX4000)" on page 310.
Installing the new GPU card
▶
Install the GPU card, see "Installing the GPU card in a riser module
(example NVDIA Tesla A100)" on page 291 or "Installing the GPU card in a
riser module (example NVDIA RTX4000)" on page 299.
Concluding steps
▶
"Reassembling" on page 60.
▶
Connect all external cables to the expansion card(s).
▶
"Connecting the power cord" on page 65.
▶
"Switching on the server" on page 69.
▶
If applicable, "Installing the front cover with lock" on page 69.
▶
If applicable, update the system information of your server using the Chassis
ID Prom Tool, see "Using the Chassis ID Prom Tool" on page 110.
Expansion cards and backup units
RX2540 M6 Upgrade and Maintenance Manual 313
To Next Page
Loading...
