81
Masterpiece
User Manual
The menu below displays an audio shuffle on input channels 1 & 2 and 3 & 4. Their default state
was Inputs 1 & 2 to outputs 1 & 2 and Inputs 3 & 4 to Outputs 3 & 4.
Input audio channels 1 & 2 are now moved to be Output on channels 4 & 5 and Input channels
3 & 4 are moved to be output on channels 7 & 8. This is now Audio Shuffle 1 and named
“SHUFFLE 1”
The Shuffle Profile can now be assigned to a crosspoint. In the “Crosspoint Mapping” menu,
select the required crosspoint, then touch the “Audio Shuffle” parameter, use the parameter
control to select “SHUFFLE 1”. The shuffle profile is now added to the audio source that is
associated with the crosspoint.
The shuffle profile is saved when the User Config is saved and when the Switcher State is saved.
Note: The red dotted lines have been added to highlight the audio shuffle
profile created. They are not part of the original menu.
To Next Page
Loading...
