112
Engineering, User & Panel Configuration
Output Setup
Output Tally
The GPO Tallies can be set to provide up to 8 further output Tallies ISO1 to ISO8. These can be
used to Tally outputs that are being used as ISO (isolation) Feeds.
Tally Now sets the tally for the on-air Sources (red). Set this for the PGM output.
Tally Next - This sets the Tally for the next on-air source. Set this for the PVW Output.
In addition to the on-air source tally lights, you can set additional tally lights called ISO. ISO is
the abbreviation for “isolated”, and indicates that the video signal is isolated and recorded
separately. The ISO Tally’s can be used for example in a studio situation where studio cameras
are recording live and/or live to disk or tape.
To Next Page
Loading...
