118
Engineering, User & Panel Configuration
Protocols
After the Load button was touched, the selected protocol is placed in the Loaded Protocols
table, touch the {Configure} button to enter the Protocol Config menu.
The user is able to select the type of connection that is required “Transport Type” i.e Serial or
IP, and also set user-defined parameters for the protocol.
The Settings - Default as the name suggests is the default setup to communicate with an
external device (normally this would default to “RS422 Port”). If a specific setup is needed, press
the {User} button in the Settings parameter, the user is now able to setup the protocol as
required.
When the parameters have been set correctly press the {Apply} button. The menu will now
return to the main Protocols menu.
To Next Page
Loading...
