GRASS VALLEY MASTERPIECE User Manual

125
Masterpiece
User Manual
Enable UDP Listener, then set the IP Address to be that of the computer. Set the port number to
be 514 (or what ever it was set to on Masterpiece).
Click on {OK} and the Syslog software should now start receiving messages from Masterpiece.
Note: Usually, Syslog servers will use UDP port #514, although they will offer
the ability to change this port, allowing the Grass Valleye machine to run
multiple Syslog servers simultaneously.

GRASS VALLEY MASTERPIECE Specifications

General

Brand	GRASS VALLEY
Model	MASTERPIECE
Category	Switch
Language	English