215
Masterpiece
User Manual
Wipe Control Parameters
Pattern - Adjust to select the required wipe pattern. There are a number of individual wipe
patterns available. The number of available wipe patterns will vary depending on whether the
background or Key is selected.
Softness - This parameter adjusts the softness of the leading edge or edges of the selected
wipe pattern. 0% is the default setting which Shows a hard clean edge and 100% blends the
edge into the background making it barely visible until the transition is complete.
Position - Touch any one of the On/Off buttons in the parameter controls. This will set all the
buttons to the On position if they are currently off.
X Position Y Position - The wipe start position can be adjusted to start anywhere on-screen by
changing the parameters in the X/Y Position attacher box. Touching any of the On/Off buttons
will activate all three parameter boxes. Notice that the Red indicators in the parameter boxes
are triangles denoting that the parameters can be adjusted using the rotary controls or by
using the joystick on the control panel.
Rotation - This will rotate the wipe pattern clock-wise or counter clock-wise in increments.
Border - This turns the border function On/Off
Border Width - If a border has been selected for example on a square wipe which starts from
the center of the screen, the width of the border in relation to the edge of the wipe can be
adjusted.
Border Fill - Select the border Fill from either a Matte or one of the two Util Buses, as described
in the Mix menu structure.
Matte Selector - Select the required Matte from the options or Local Matte.
Hue, Luma and Saturation will only affect the Local Matte setting.
Hue - sets the actual Matte color. The rotary control operates a 360 degree color wheel where:
0 = Red
60 = Magenta
120 = Blue
180 = Cyan
240 = Green
300 = Yellow
Luma - The Luminance or brightness control affects the selected Matte Hue. The parameter
adjusts from 0 to 100% where 0% is no luminance or Black and 100% is maximum brightness.
Sat - The saturation control affects the selected Matte Hue. The parameter adjusts from 0 to
100% where 0% is no saturation or no color i.e. only shades of Gray and 100% is fully saturated
or maximum color.
Aspect Ratio - Touch the On/Off button to activate the aspect ration function. As the name
suggests, this function changes the aspect ratio of a wipe pattern, 0 to -100% will change the
vertical ratio and 0 to +100% will adjust the horizontal ratio.
Note: Aspect ratio will only adjust a limited number of the wipe patterns.
To Next Page
Loading...
