221
Masterpiece
User Manual
VFreq - controls the vertical frequency (number of peaks per centimeter) of the modulation
VPhase - controls the start point of the of the modulation and thus the relative position of the
peaks and troughs to the vertical edge of the wipe.
Repeats Enable
The Repeats menus will as the name suggests, this will repeat the wipe pattern a user-defined
number of times.
Turn the Repeats Enable parameter On
Wipe Repeats - Horizontal/Vertical, this will determine the number of repeated wipe patterns
horizontally or vertically.
Wipe Blocks - With some wipe patterns that use a block effect, such as wipe shapes 89, 90, 91
for example, adjusting these parameters will add extra horizontal an vertical blocks to the wipe
effect.
Example of Vertical Modulation
To Next Page
Loading...
