279
Masterpiece
User Manual
Parameter Controls
Active Sub-Clips - this displays the number of sub-clips within the selected Store.
Position - displays the current run time of the selected clip
Play Rate - this can be used increase or decrease the play rate of a clip. It has to be “Enabled”
for this function to work. The default is set to “1.00” which is normal speed.
Playback Mode - The user has the option to play back Clips in Field or Frame mode, or Field 1
Only or Field 2 Only using the Playback Mode parameter control.
This feature can be used if a Clip is made from a sequence of individual Stills. If each Still is a
Frame in duration the user can Play/Position the Still and in the Stop state, both fields (Full
resolution) will be displayed. If the material is Field-based then in Frame mode the user will risk
seeing flickering images from two different fields.
Loop Count - this parameter selects how many times a clip is played back in a loop. When set to
“0” the clip will pay until stopped. The parameter can be adjusted from 1 to 100 loop counts.
Audio Delay - if the audio needs to start later than the video, the Audio Delay parameter can
be adjusted.
When set to 0% (default) the audio and video will start at the Grass Valleye time, +100% the
audio will start after the video finishes. -100% the video starts after the audio has finished.
Trans Duration- this parameter displays the current Transition Duration time. The user is able
to use this information when setting up an audio/video clip to be used in a clip transition.
To Next Page
Loading...
