337
Masterpiece
User Manual
If the source is UHD set the “UHD” parameter to “Yes”.
If the router has its sources and destinations ganged as UHD then set “UHD Router” = Ye s . This
differentiates between the control protocol setting 4 router XPTs (un-ganged) or just the first
router XPT (ganged).
“Name From” - Router means the name is fed into the Masterpiece from the external router
(should the protocol allow this).
“Name From” - Crosspoint uses the internal XPT name as set in the User Config - Crosspoint -
Name menu.
Repeat the above for the “Key Source” for the Xpt if required. Otherwise it's recommended to
set the Key source to black or white for the external router XPT.
Make sure at this point to “Overwrite” or “Save” the User Config.
Note: When in UHD mode the 4 quadrants or streams from the router have
to be consecutive.
To Next Page
Loading...
